Journal of Composites for Construction: Recent submissions
Now showing items 1901-1920 of 2137
-
Repair of Steel Composite Beams with Carbon Fiber-Reinforced Polymer Plates
(American Society of Civil Engineers, 2004)One significant cause of deterioration of steel bridge structures is the corrosion due to extensive use of deicing salts in winter weather. The investigation presented in this paper focused on the behavior of steel composite ... -
Torsional Strengthening of Spandrel Beams with Fiber-Reinforced Polymer Laminates
(American Society of Civil Engineers, 2004)Research has shown that fiber-reinforced polymer (FRP) composites can increase flexural, axial, and shear capacity of beams, columns, and walls. The present paper describes both experimental and analytical programs focused ... -
Bond Behavior of Fiber Reinforced Polymer Bars under Direct Pullout Conditions
(American Society of Civil Engineers, 2004)This paper examines the behavior of Eurocrete fiber-reinforced polymer (FRP) bars (glass, carbon, aramid, and hybrid) in concrete under direct pullout conditions. More than 130 cube specimens were tested in direct pullout ... -
Strengthening of Masonry Walls against Out-of-Plane Loads Using Fiber-Reinforced Polymer Reinforcement
(American Society of Civil Engineers, 2004)Thirty masonry walls strengthened using three different fiber-reinforced polymer (FRP) systems, with three anchorage methods, were fabricated and tested under a concentrated load over a 100 mm square area or a patch load ... -
Fatigue Behavior of Reinforced Concrete Beams Strengthened with Carbon Fiber Reinforced Plastic Laminates
(American Society of Civil Engineers, 2004)Although there has been growing interest and field applications of poststrengthening concrete structures using carbon fiber reinforced plastic (CFRP) laminates, very little information exists regarding the flexural fatigue ... -
Structural Model to Predict the Failure Behavior of Plated Reinforced Concrete Beams
(American Society of Civil Engineers, 2004)This paper presents a theoretical model, based on truss analogy, to analyze the structural behavior at failure of reinforced concrete beams with steel plates or fiber-reinforced polymer lamitates bonded to their tension ... -
Energy Release in Fiber-Reinforced Plastic Reinforced Concrete Beams
(American Society of Civil Engineers, 2004)A set of 30 concrete beams reinforced with carbon/epoxy FRP (fiber-reinforced plastic) and four reinforced with comparable size steel rebars were subjected to static bending tests. Adequate bond between the FRP and the ... -
Seismic Retrofit of Hollow Rectangular Bridge Columns
(American Society of Civil Engineers, 2004)The seismic performance of rectangular hollow bridge columns is a significant issue of the high-speed rail project in Taiwan. The flexural ductility and shear capacity of such columns with the configuration of lateral ... -
Failure Mode Analyses of Reinforced Concrete Beams Strengthened in Flexure with Externally Bonded Fiber-Reinforced Polymers
(American Society of Civil Engineers, 2004)As existing structures age or are required to meet the changing demands on our civil infrastructure, poststrengthening and retrofitting are inevitable. A relatively recent technique to strengthen reinforced concrete (RC) ... -
Development of a Specification for Bridge Seismic Retrofit with Carbon Fiber Reinforced Polymer Composites
(American Society of Civil Engineers, 2004)The U.S. Interstate 80 bridge over State Street in Salt Lake City is very near the Wasatch fault, which is active and capable of producing large earthquakes. The bridge was designed and built in 1965 according to the 1961 ... -
Strength and Ductility of Concrete Beams Reinforced with Carbon Fiber-Reinforced Polymer Plates and Steel
(American Society of Civil Engineers, 2004)Seven concrete beams reinforced internally with varying amounts of steel and externally with precured carbon fiber-reinforced polymer (FRP) plates applied after the concrete had cracked under service loads were tested under ... -
Acoustic Emission Characterization of Damage in Hybrid Fiber-Reinforced Polymer Rods
(American Society of Civil Engineers, 2004)The development and testing of a pseudoductile hybrid fiber-reinforced polymer rod consisting of glass and carbon fibers is described. Two different hybrid forms were considered for the development of the hybrid rods, ... -
Flexural and Shear Rigidity of Composite Sheet Piles
(American Society of Civil Engineers, 2003)The flexural and shear rigidity of pultruded composite sheet pile panels consisting of E-glass fiber-reinforced polyester are studied in this paper. The analysis consists of an experimental investigation and an analytical ... -
Application of Fiber Reinforced Polymer Overlays to Extend Steel Fatigue Life
(American Society of Civil Engineers, 2003)An experimental and analytical study was conducted to investigate the effectiveness of applying carbon fiber reinforced polymer (CFRP) overlays to steel fatigue tension coupons to prolong fatigue life. Specimens were either ... -
Prestressed Carbon Fiber Reinforced Polymer Sheets for Strengthening Concrete Beams at Room and Low Temperatures
(American Society of Civil Engineers, 2004)A technique for strengthening damaged concrete beams using prestressed carbon fiber reinforced polymer (CFRP) sheets was developed at Queen’s University and the Royal Military College of Canada. As part of this study, an ... -
Repair of Damaged Steel-Concrete Composite Girders Using Carbon Fiber-Reinforced Polymer Sheets
(American Society of Civil Engineers, 2003)The aging infrastructure of the United States requires significant attention for developing new materials and techniques to effectively and economically revive this aging system. Damaged steel-concrete composite girders ... -
Reinforced Concrete T-Beams Strengthened in Shear with Fiber Reinforced Polymer Sheets
(American Society of Civil Engineers, 2003)This research studies the interaction of concrete, steel stirrups, and external fiber reinforced polymer (FRP) sheets in carrying shear loads in reinforced concrete beams. A total of eight tests were conducted on four ... -
Bond Strength of Tension Lap Splices in High-Strength Concrete Beams Strengthened with Glass Fiber Reinforced Polymer Wraps
(American Society of Civil Engineers, 2004)This paper presents the experimental results of the first phase of a study undertaken at the American University of Beirut to examine the effectiveness of fiber reinforced polymer (FRP) wraps to confine steel reinforcement ... -
Flexural Behavior of R/C Beams Strengthened with Carbon Fiber Reinforced Polymer Sheets or Fabric
(American Society of Civil Engineers, 2003)Their resistance to electro-chemical corrosion, high strength-to-weight ratio, larger creep strain, fatigue resistance, and nonmagnetic and nonmetallic properties make carbon fiber reinforced polymer (CFRP) composites a ... -
Corrosion of Steel Reinforcement in Carbon Fiber-Reinforced Polymer Wrapped Concrete Cylinders
(American Society of Civil Engineers, 2003)The rehabilitation, repair, and strengthening of concrete structures has increased worldwide with a growing number of systems employing externally applied fiber-reinforced polymer (FRP) composites. However, the service ...