ASCE: Recent submissions
Now showing items 2461-2480 of 107386
-
Durability Assessment of Fiber-Reinforced Limestone Calcined Clay Cement Composites after Exposure to High Temperatures
(American Society of Civil Engineers, 2025)AbstractVarious supplementary cementitious materials (SCMs) with fiber reinforcement have been tested to enhance the performance of concrete exposed to high temperatures. However, despite their numerous advantages, SCM-based ... -
Geotechnical Application of Methylobacterium radiotolerans in Expansive Soil: Bacterial Isolation and Optimization Using Response Surface Method
(American Society of Civil Engineers, 2026)AbstractThe present study focuses on enhancing the unconfined compressive strength (UCS) of an expansive soil with the help of microbially induced calcite precipitation (MICP). Here, Methylobacterium radiotolerans (MRT) ... -
Effect of High Steel Fiber Volume Fraction on the Mechanical Properties of Ultrahigh-Performance Concrete Incorporating Entirely Recycled Fine Aggregates
(American Society of Civil Engineers, 2025)AbstractThis study investigated the effect of high steel fiber volume fraction on the workability and mechanical properties of ultrahigh-performance concrete (UHPC) containing entirely recycled fine aggregates (RFAs). The ... -
Investigation into the Corrosion Behavior of Reinforcement Embedded in Precracked Sea-Sand Ultrahigh-Performance Concrete Matrix
(American Society of Civil Engineers, 2025)AbstractThe long-term corrosion behavior of steel bar embedded in sea-sand ultrahigh-performance concrete (UHPC) with different prefabricated crack widths immersed in pure water is investigated. The experimental results ... -
Molecular-Scale Study of the Compatibility of Warm-Mix Agents, Rubber, and Asphalt in Warm-Mix Rubber Asphalt
(American Society of Civil Engineers, 2025)AbstractWarm-mix rubber asphalt was analyzed in this study. Based on material characterization test results, a molecular model of warm-mix rubber asphalt was established using Materials Studio software. According to polymer ... -
Experimental Study on the Use of Tomato and Pepper Stem Waste in Lime-Stabilized Unfired Earth Blocks: Evaluating Mechanical and Hygroscopic Properties
(American Society of Civil Engineers, 2025)AbstractThis study explores the use of plant waste–derived materials in earthen building construction to address global warming, specifically how different percentages of tomato stem waste (TSW) and pepper stem waste (PSW) ... -
Anisotropic Deformation and Fracture Mechanism of a Deep Marble under True Triaxial Stress: A Multiscale Investigation
(American Society of Civil Engineers, 2025)Abstract True triaxial compression tests were conducted on deep-buried marble (deep marble for short) using a true triaxial disturbance unloading test system under different initial stress conditions. The effects of initial ... -
Permeability of Roller-Compacted Concrete after Various Loading Levels
(American Society of Civil Engineers, 2025)AbstractThe novelty of this study lies in investigating the simultaneous effects of applied loading, supplementary cementitious materials (SCMs), and interlayer cold joints on the permeability of roller-compacted concrete ... -
Life Cycle Assessment of Lightweight Ceramic Clay Aggregates Sintered in a Microwave Oven with the Incorporation of Sargassum spp. Particles
(American Society of Civil Engineers, 2025)AbstractSargassum spp. is a brown seaweed originally found in the Sargasso Sea, in the tropical Atlantic region and Gulf of Mexico. Its increase in recent years and its movement toward the coastline has become a serious ... -
Mechanical Properties and Deterioration Mechanism of Concrete–Mortar Joint Interface after Exposure to High Temperature
(American Society of Civil Engineers, 2025)AbstractMortar is commonly used as a reinforcement and repair material for concrete structures, and the interface of the formed concrete–mortar joints is in the weak point of stress. Since there is a fire risk during the ... -
Simultaneous Reinforcement of Sand and Mortar Cracks Using Enzyme-Induced Carbonate Precipitation
(American Society of Civil Engineers, 2025)AbstractEnzyme-induced calcium carbonate precipitation (EICP) technology shows great potential for reinforcing granular materials and sealing cracks. This study investigates the coreinforcement of sand and mortar cracks ... -
Microstructural Characteristics and Mechanical Properties of YSt-355 Structural Steel
(American Society of Civil Engineers, 2025)AbstractThe introduction of YSt-355 plain carbon steel, with its higher nominal yield strength, is poised to replace YSt-310 in the steel construction industry. Despite this potential, comprehensive studies on the ... -
Analysis and Procedure for Conducting Laboratory Dielectric Measurements for Bulk Specific Gravity Determination
(American Society of Civil Engineers, 2025)AbstractThe use of a laboratory dielectric measurement system (LDMS), based on ground penetrating radar (GPR) technology, was explored in this study to alleviate the shortcomings (in terms of equipment, measurements and ... -
Self-Healing Mechanisms of Cement-Based Materials Including Different Ion Complexing Agents
(American Society of Civil Engineers, 2025)AbstractThis study explores the impact of four ion complexing agents on the self-healing behavior of cement-based materials, to elucidate the self-healing mechanisms of cement-based materials including various ion complexing ... -
Evaluation of Moisture Impact on Bituminous Mixtures Enhanced with Reclaimed Asphalt Pavement and Sawdust Ash
(American Society of Civil Engineers, 2025)AbstractThis study investigated the influence of moisture on asphalt concrete (AC) mixtures incorporating varying proportions of recycled asphalt pavement (RAP) and 8% sawdust ash (SDA). The optimum bitumen content (OBC) ... -
Effect of Acid on the Crystal Phase and Water Resistance Properties of Magnesium Oxysulfate Cement
(American Society of Civil Engineers, 2025)AbstractIn this paper, the effects of eight different types of acids (oxalic, silicic, acetic, salicylic, citric, phosphoric, tartaric, and malonic acids) on the mechanical properties, water resistance, physical phase ... -
Experimental Investigation of Shear Strength Parameters of Rubber-Coated Ballast
(American Society of Civil Engineers, 2025)AbstractCovering ballast aggregates with rubber particles is referred to in the literature as rubber-coated ballast (RCB). Although this approach reduces the abrasion and crushing of the ballast and increases its damping, ... -
Rigid Drainage Pile Performance in Sandy Soils: Transparent Soil Technology, Particle Image Velocimetry,and 3D Printing Insights
(American Society of Civil Engineers, 2025)Abstract This study delved into the penetration of rigid-drainage piles into sand, utilizing transparent soil technology for model tests. The research used advanced particle image velocimetry to evaluate soil displacement ... -
Optimization and Performance Prediction of SBS-Modified Asphalt Crack Sealant Using Entropy Weight and ANFIS Methods
(American Society of Civil Engineers, 2025)AbstractCracks in asphalt pavement can compromise structural integrity and accelerate deterioration if left unsealed. Crack sealing is a crucial maintenance practice for extending pavement lifespan, but the varying performance ... -
Study on Applicability and Compressive Performance of Recycled Aggregate in Hydraulic Asphalt Concrete
(American Society of Civil Engineers, 2025)AbstractIn order to investigate the applicability of recycled aggregates in hydraulic asphalt concrete (HAC), mix proportion and compressive performance tests were conducted. The optimal substitution ratio of recycled ...