Show simple item record

dc.contributor.authorTadeusz M. Drzewiecki
dc.date.accessioned2017-05-09T01:37:53Z
dc.date.available2017-05-09T01:37:53Z
dc.date.copyrightSeptember, 1974
dc.date.issued1974
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26016#358_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/164638
dc.description.abstractA possible fluidic load cell design consists of three parts: a structural member that deforms linearly with load, a fluidic strain gage having fluidic resistance that changes with deformation, and a three-stage laminar proportional amplifier-gain block that amplifies the change in strain gage through-flow to useful levels. This Technical Brief presents design relations for the first two parts of such a system. Two compressive load cells were built, incorporating different fabrication techniques and deformation-sensing methods. The loading range of these cells is about 0 to 20 kN (0 to 2 tons) with a dynamic range greater than 100 and a typical full-scale output pressure of 30 pascals (4 × 10−3 psi). Possible applications for fluidic load cells include force measurements in highly incendiary or radiative environments and/or when other fluid control circuitry is used.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Fluidic Load Cell
dc.typeJournal Paper
dc.journal.volume96
dc.journal.issue3
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.3426815
dc.journal.fristpage358
dc.journal.lastpage360
dc.identifier.eissn1528-9028
dc.keywordsStress
dc.keywordsDeformation
dc.keywordsDesign
dc.keywordsStrain gages
dc.keywordsForce measurement
dc.keywordsFluids
dc.keywordsManufacturing
dc.keywordsElectrical resistance
dc.keywordsKnudsen number
dc.keywordsPressure AND Flow (Dynamics)
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1974:;volume( 096 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record