Show simple item record

dc.contributor.authorD. W. Pessen
dc.contributor.authorJ. Rogozinski
dc.date.accessioned2017-05-09T01:36:18Z
dc.date.available2017-05-09T01:36:18Z
dc.date.copyrightMarch, 1973
dc.date.issued1973
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-25998#44_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/163717
dc.description.abstractThe negative-inertia mechanism consists of a double-worm drive with a small flywheel attached to the output shaft. By connecting the drive in parallel with the servo load, very high deceleration rates can be obtained. The drive thus effectively cancels most of the load inertia, as long as the load is decelerated. During acceleration, the drive adds slightly to the original load inertia. Characteristic design equations of the system are described, and experimental results presented. The drive is intended mainly for velocity servos, where very high decelerating torques are required without using clutch-brake mechanisms or excessively large servomotors.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleImprovement of Servo Transient Response by Frictional “Negative-Inertia” Mechanism
dc.typeJournal Paper
dc.journal.volume95
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.3426648
dc.journal.fristpage44
dc.journal.lastpage48
dc.identifier.eissn1528-9028
dc.keywordsInertia (Mechanics)
dc.keywordsServomechanisms
dc.keywordsTransients (Dynamics)
dc.keywordsMechanisms
dc.keywordsStress
dc.keywordsFlywheels
dc.keywordsServomotors
dc.keywordsBrakes
dc.keywordsDesign AND Equations
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1973:;volume( 095 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record