Show simple item record

dc.contributor.authorOkajima, Satoshi
dc.contributor.authorWakai, Takashi
dc.contributor.authorAndo, Masanori
dc.contributor.authorInoue, Yasuhiro
dc.contributor.authorWatanabe, Sota
dc.date.accessioned2017-05-09T01:32:52Z
dc.date.available2017-05-09T01:32:52Z
dc.date.issued2016
dc.identifier.issn0094-9930
dc.identifier.otherpvt_138_05_051204.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/162399
dc.description.abstractIn this paper, we simplify the existing method and propose a screening method to prevent thermal ratcheting strain in the design of practical components. The proposed method consists of two steps to prevent the continuous accumulation of ratcheting strain. The first step is to determine whether all points through the wall thickness are in the plastic state. This is based on an equivalent membrane stress, which comprises the primary stress and the secondary membrane stress. When the equivalent stress exceeds the yield strength in some regions of the cylinder, the axial lengths of these regions are measured for the second step. The second step is to determine whether the accumulation of the plastic strain saturates. For this purpose, we define the screening criteria for the length of the area with full section yield state. When this length is sufficiently small, residual stress is generated in the direction opposite to the plastic deformation direction. As a result of residual stress, further accumulation of the plastic deformation is suppressed, and finally shakedown occurs. To validate the proposed method, we performed a set of elastoplastic finite element method (FEM) analyses, with the assumption of elastic perfectly plastic material. Not only did we investigate about the effect of the axial length of the area with full section yield state but also we investigated about effects of spatial distribution of temperature, existence of primary stress, and radius thickness ratio.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Screening Method for Prevention of Ratcheting Strain Derived From Movement of Temperature Distribution
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue5
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4032989
dc.journal.fristpage51204
dc.journal.lastpage51204
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2016:;volume( 138 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record