Show simple item record

dc.contributor.authorNemchinsky, Valerian
dc.date.accessioned2017-05-09T01:30:46Z
dc.date.available2017-05-09T01:30:46Z
dc.date.issued2016
dc.identifier.issn0022-1481
dc.identifier.otherht_138_12_122301.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/161724
dc.description.abstractHeat transfer in a metal cut by a moving arc jet is considered using the method of superposition of heat sources and sinks. The heat sources are located at the plasma–liquid metal boundary, heat sinks—at the melting front. Special attention is paid to the influence of the molten metal layer that separates the plasma and not yet molten metal. It is shown that this layer hampers heat transfer to the melting front. Neglecting its heat resistance could lead to a very substantial errors especially at high cutting speeds. The thicker the layer and/or the higher the cutting speed, the more power is necessary to perform the cut and the higher the average temperature of the melt. Estimations show that power carried out by the removed melt could reach half of the total power necessary to make the cut. The suggested method allows one to include the heat of heterogeneous reaction of oxidation at the melting front. The method could be applied to describe other types of metal cutting with a moving concentrated heat source.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTemperature Created by a Moving Heat Source That Heats and Melts the Metal Plate (Plasma Arc Cutting)
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue12
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4034309
dc.journal.fristpage122301
dc.journal.lastpage122301
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2016:;volume( 138 ):;issue: 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record