Show simple item record

dc.contributor.authorKim, Jinsub
dc.contributor.authorJun, Seongchul
dc.contributor.authorLee, Jungho
dc.contributor.authorLee, Seong Hyuk
dc.contributor.authorYou, Seung M.
dc.date.accessioned2017-05-09T01:30:39Z
dc.date.available2017-05-09T01:30:39Z
dc.date.issued2016
dc.identifier.issn0022-1481
dc.identifier.otherht_138_08_080910.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/161686
dc.description.abstractThree different copper surfaces bare, Al2O3 nanocoated, and Polytetrafluoroethylene (PTFE) coated are prepared and tested to examine the effect of wettability on the pool boiling incipience in saturated water at 1 atm. A copper surface is coated with Al2O3 particles ranging 25~43 nm in diameter by immersing the surface in Al2O3/ethanol nanofluid (1g/l) and boiled for 3 min. SEM image in Fig. 1 shows the coated Al2O3 nanoparticles on the copper surface, together with the reference bare surface. PTFE coating is also applied to the copper surface using spin coating method with the mixture of Dupont AF 2400 particles and 3M FC40 solvent. The final coating thickness of the PTFE coating is estimated to be 30 nm. The three surfaces exhibit different static contact angles, 78آ° (bare), 28آ° (nanocoated), and 120آ° (PTFE coated) in Fig. 2, respectively. Wettability affects the boiling incipience heat flux where initial bubble nucleation starts: 15 kW/m2 for the bare surface; 30 kW/m2 for the nanocoated surface; and 2.5 kW/m2 for the PTFE coated surface. Captured images from the high speed camera at 2,000 fps show significantly different bubble shapes and departure frequencies in Fig. 3. During the bubble growth, advancing contact angles are captured and shown qualitatively and found consistent with their static angle measurements for the sessile droplet observed at each surface. The larger bubble is generated on the nanocoated surface compared to that of the bare surface because improved wetting makes promising cavities flood and thus incipience is delayed, resulting in higher superheat. The single bubble life cycle appears to be much longer on the PTFE coated surface due to the increase of the contact angle which becomes hydrophobic (> 90آ°), resulting in lower bubble departure frequency. Successive tests at the same heat flux of 30 kW/m2 confirmed that life cycle on the PTFE coated surface (88.5 ms) is consistently longer than that on the bare surface (16.5 ms) and nanocoated surface (20 ms).
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Wettability on Pool Boiling Incipience in Saturated Water
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue8
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4033815
dc.journal.fristpage80910
dc.journal.lastpage80910
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2016:;volume( 138 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record