Show simple item record

dc.contributor.authorAly, Wael I. A.
dc.date.accessioned2017-05-09T01:30:35Z
dc.date.available2017-05-09T01:30:35Z
dc.date.issued2016
dc.identifier.issn0022-1481
dc.identifier.otherht_138_10_101801.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/161662
dc.description.abstractLaminar flow and heat transfer behaviors of two different metal oxide, Al2O3 (36 nm) and CuO (29 nm), nanofluids flowing through an annular coiled tube heat exchanger (ACTHE) with constant wall temperature boundary condition have been numerically studied to evaluate their superiority over the base fluid (water). Simulations covered a range of nanoparticles volume concentrations of 1.0–6.0% and mass flow rates from 0.025 to 0.125 kg/s. Numerical results indicated that a considerable heat transfer enhancement is achieved by both nanofluids. Results at the same Reynolds number for the pressure drop and heat transfer coefficient show an increase with increasing particle volumetric concentration. The maximum enhancements in heat transfer coefficient were 44.8% and 18.9% for CuO/water and Al2O3/water, respectively. On the other hand, the pressure loss was seven times in comparison to water for CuO/water and about two times for Al2O3/water nanofluid. Also, comparing to the base fluid, nanofluids at low concentrations (up to 3%) can provide the same heat transfer amount at lower pumping power. The overall performance of the enhanced heat transfer technique utilized has been evaluated using a thermohydrodynamic performance index which indicated that Al2O3/water nanofluid is a better choice than CuO/water nanofluid. Moreover, conventional correlations for helical circular tubes for predicting friction factor and average heat transfer in laminar flow regime such as the correlations of Mori and Nakayam and Manlapaz and Churcill, respectively, are also valid for water and the tested nanofluids with small nanoparticle loading in the ACTHE.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThermal and Hydrodynamic Performance of Aqueous CuO and Al2O3 Nanofluids in an Annular Coiled Tube Under Constant Wall Temperature and Laminar Flow Conditions
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue10
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4033613
dc.journal.fristpage102401
dc.journal.lastpage102401
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2016:;volume( 138 ):;issue: 010
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record