Show simple item record

dc.contributor.authorArأ©valo, Rubأ©n
dc.contributor.authorAbأ،nades, Alberto
dc.contributor.authorRebollo, Luis
dc.date.accessioned2017-05-09T01:30:27Z
dc.date.available2017-05-09T01:30:27Z
dc.date.issued2016
dc.identifier.issn0022-1481
dc.identifier.otherht_138_07_072701.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/161622
dc.description.abstractFilm boiling is a heat transfer mechanism that might appear in different processes, such as cryogenics, metallurgical, and nuclear reactors during abnormal operating conditions, as happens during a loss of coolant accident. In this research, film boiling around a finite vertical cylinder was studied by means of computational fluid dynamics (CFD) simulations, considering six cases that include three different levels of surface temperature and two different shapes of the cylinder ends: flat and hemispherical ends. Volume of fluid (VOF) method for the treatment of multiphase flow was used, and a userdefined function was programed to consider the exchange of mass and energy between the phases. The simulations were performed with a vertical cylinder of 32 mm in diameter and 32 or 64 mm in high for flat ends or hemispherical ends, respectively, placed in a twodimensional axisymmetric domain of 0.125 m أ— 0.25 m. Results obtained for the heat flux show a periodic fluctuating behavior in time as a consequence of periodical variations in the thickness of the vapor film around the cylinder. A wavy liquid–vapor interface is observed as is reported in the experimental works. The simulations results are compared with the experimental values reported in literature as well as with values obtained from correlations. The results show that the computational code used captures reasonably well the physics involved in the film boiling, being obtained that average heat flux to the case of hemispherical ends is 15.6% higher than for the case of flat ends, versus 15.2% showing experiments and 1.6% calculated combining correlations for the individual surfaces. It shows that use of correlations in this way is not appropriate in film boiling because it does not take into account the interactions between the different surfaces.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical Research of Film Boiling Heat Transfer Around a Vertical Short Cylinder With Flat or Hemispherical Ends
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4033094
dc.journal.fristpage74502
dc.journal.lastpage74502
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2016:;volume( 138 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record