Show simple item record

dc.contributor.authorIzquierdo
dc.contributor.authorSobrino, C.
dc.contributor.authorAlmendros
dc.date.accessioned2017-05-09T01:30:24Z
dc.date.available2017-05-09T01:30:24Z
dc.date.issued2016
dc.identifier.issn0022-1481
dc.identifier.otherht_138_07_072001.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/161608
dc.description.abstractThe objective of this work is to model the heat transfer coefficient between an immersed surface and fixed and bubbling fluidized beds of granular phase change material (PCM). The model consists of a tworegion model with two different voidages in which steady and transient conduction problems are solved for the fixed and fluidized bed cases, respectively. The model is validated with experimental data obtained under fixed and fluidized conditions for sand, a common material used in fixed and fluidized beds for sensible heat storage, and for a granular PCM with a phase change temperature of approximately 50 آ°C. The superficial gas velocity is varied to quantify its influence on the convective heat transfer coefficient for both the materials. The model proposed for the PCM properly predicts the experimental results, except for high flow rates, which cause the contact times between the surface and particles to be very small and lead the model to overpredict the results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleModeling the Heat Transfer Coefficient Between a Surface and Fixed and Fluidized Beds With Phase Change Material
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4032981
dc.journal.fristpage72001
dc.journal.lastpage72001
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2016:;volume( 138 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record