• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Contact Angle Measurement of Liquid Hydrogen (LH2) in Stainless Steel and Aluminum Cells

    Thumbnail
    View/Open
    ht_138_02_020904.pdf (416.5Kb)
    Date
    2016
    Author
    Bellur, Kishan
    Konduru, Vinaykumar
    Kulshrestha, Manan
    Tyrewala, Daanish
    Medici, Ezequiel
    Allen, Jeffrey S.
    Choi, Chang Kyoung
    Hussey, Daniel S.
    Jacobson, David C.
    Leأ£o, Juscelino B.
    McQuillen, John
    Hermanson, James
    Tamilarasan, Arun
    Metadata
    Show full item record
    Abstract
    One of the key limitations to longterm space missions is to avoid propellant boiloff in a microgravity space environment. Even with the use of active and passive controls of propellants, boil off is inevitable. Longterm CFD simulations on propellant behaviors depend on evaporation/condensation coefficients (known as accommodation coefficients) which are in turn dependent upon the wetting characteristics. Phase change experiments were conducted in the BT2 neutron imaging facility at the National Institute of Standards and Technology (NIST) by introducing vapor H2 in 10 mm Al6061 and SS316L test cells placed inside the 70mm â€کorange’ cryostat. Condensation is achieved by lowering the cryostat temperature below the saturation point and vice versa for evaporation. The high neutron crosssection of liquid H2 in comparison to both the vapor and the test cell materials allows for visualization of a distinct liquidvapor interface. Multiple images are stacked to increase the signaltonoise ratio and the meniscus edge is obtained by detecting the pixels with largest gradients in intensities at the liquid meniscus. The contact angle is obtained by curve fitting of the YoungLaplace equation to the detected meniscus. The contact angle for Al6061 and SS316 is found to be between 0آ° and 4آ°. The uncertainty arises from edge detection, magnification, and resolution limits of the neutron imaging setup. The test was conducted at a saturation temperature of 21K (1.215 bar). The results from the neutron experiments will be then used in conjunction with FEA thermal models and kinetic phase change models to extract accommodation coefficients.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/161547
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV