Show simple item record

dc.contributor.authorKline, N.
dc.contributor.authorTavoularis, S.
dc.date.accessioned2017-05-09T01:30:00Z
dc.date.available2017-05-09T01:30:00Z
dc.date.issued2016
dc.identifier.issn0022-1481
dc.identifier.otherht_138_01_012502.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/161491
dc.description.abstractAn experimental study of the effect of eccentricity on forced convective heat transfer was conducted for upward flows in vertical, openended annular channels with a diameter ratio of 0.61, a length to outer diameter ratio of 18:1, and both internal surfaces heated uniformly. Flows with Reynolds numbers Re = 5450, 10,000, and 27,500 and eccentricities varying from 0 to 0.9 were examined. These results are deemed to be mostly in the forced convection regime with some possible overlap with the mixed convection regime at the lowest Reynolds number considered. This work complements our previous work on natural and mixed convection using the same facility. The effect of eccentricity was not significant at lower eccentricities, but, in highly eccentric cases, the wall temperature in the narrow gap was much higher than in the wide gap and the average heat transfer coefficient was as low as onefifth of the concentric value. For Re > 10,000, the average Nusselt number for the concentric case was nearly four times higher than the value predicted by the Dittus–Boelter correlation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Study of Forced Heat Convection in Concentric and Eccentric Annular Channels
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue1
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4031160
dc.journal.fristpage12502
dc.journal.lastpage12502
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2016:;volume( 138 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record