Show simple item record

dc.contributor.authorSaha, Kaushik
dc.contributor.authorSom, Sibendu
dc.contributor.authorBattistoni, Michele
dc.contributor.authorLi, Yanheng
dc.contributor.authorQuan, Shaoping
dc.contributor.authorKelly Senecal, Peter
dc.date.accessioned2017-05-09T01:27:52Z
dc.date.available2017-05-09T01:27:52Z
dc.date.issued2016
dc.identifier.issn0195-0738
dc.identifier.otherjert_138_05_052208.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/160928
dc.description.abstractA numerical study of twophase flow inside the nozzle holes and the issuing spray jets for a multihole direct injection gasoline injector has been presented in this work. The injector geometry is representative of the Spray G nozzle, an eighthole counterbore injector, from the engine combustion network (ECN). Simulations have been carried out for a fixed needle lift. The effects of turbulence, compressibility, and noncondensable gases have been considered in this work. Standard k–خµ turbulence model has been used to model the turbulence. Homogeneous relaxation model (HRM) coupled with volume of fluid (VOF) approach has been utilized to capture the phasechange phenomena inside and outside the injector nozzle. Three different boundary conditions for the outlet domain have been imposed to examine nonflashing and evaporative, nonflashing and nonevaporative, and flashing conditions. Noticeable holetohole variations have been observed in terms of mass flow rates for all the holes under all the operating conditions considered in this study. Inside the nozzle holes mild cavitationlike and in the nearnozzle region flashboiling phenomena have been predicted when liquid fuel is subjected to superheated ambiance. Under favorable conditions, considerable flashing has been observed in the nearnozzle regions. An enormous volume is occupied by the gasoline vapor, formed by the flash boiling of superheated liquid fuel. Large outlet domain connecting the exits of the holes and the pressure outlet boundary appeared to be necessary leading to substantial computational cost. Volumeaveraging instead of massaveraging is observed to be more effective, especially for finer mesh resolutions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleModeling of Internal and Near Nozzle Flow for a Gasoline Direct Injection Fuel Injector
dc.typeJournal Paper
dc.journal.volume138
dc.journal.issue5
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4032979
dc.journal.fristpage52208
dc.journal.lastpage52208
dc.identifier.eissn1528-8994
dc.treeJournal of Energy Resources Technology:;2016:;volume( 138 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record