Show simple item record

dc.contributor.authorC. Nachtigal
dc.date.accessioned2017-05-09T01:25:40Z
dc.date.available2017-05-09T01:25:40Z
dc.date.copyrightMarch, 1972
dc.date.issued1972
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-25987#5_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/160244
dc.description.abstractThe analysis of machine tool chatter from frequency domain considerations is generally accepted as a valid representation of the regenerative chatter phenomenon. However, active control of regenerative chatter is still in its embryonic stage. It was established in reference [2 ] that a measurement of the cutting force could be effectively used in conjunction with a controller and a tool position servo system to increase the stability of an engine lathe and to improve its transient response. This paper presents the design basis for such a system, including both analytical and experimental considerations. The design procedure stems from a real part stability criterion based on the work by Merritt [1 ]. Because of the unknown variability in the dynamics of a machine tool system, the controller parameters were chosen to accomodate some mismatch between structure and tool servo dynamics. Experimental tests to determine the stability zone of the controlled machine tool system qualitatively confirmed the analytical design results. The experimental results were consistent in that the transient response tests confirmed the frequency domain stability tests. It was also demonstrated experimentally that the equivalent static stiffness of a flexible work-piece system could be substantially increased.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDesign of a Force Feedback Chatter Control System
dc.typeJournal Paper
dc.journal.volume94
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.3426544
dc.journal.fristpage5
dc.journal.lastpage10
dc.identifier.eissn1528-9028
dc.keywordsControl systems
dc.keywordsDesign
dc.keywordsChatter
dc.keywordsForce feedback
dc.keywordsStability
dc.keywordsMachine tools
dc.keywordsDynamics (Mechanics)
dc.keywordsControl equipment
dc.keywordsServomechanisms
dc.keywordsTransients (Dynamics)
dc.keywordsStiffness
dc.keywordsAnalytical design
dc.keywordsCutting
dc.keywordsEngines AND Force
dc.treeJournal of Dynamic Systems, Measurement, and Control:;1972:;volume( 094 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record