Show simple item record

dc.contributor.authorHassan, T.
dc.contributor.authorRahman, M.
dc.date.accessioned2017-05-09T01:23:02Z
dc.date.available2017-05-09T01:23:02Z
dc.date.issued2015
dc.identifier.issn0094-9930
dc.identifier.otherpvt_137_03_031002.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/159462
dc.description.abstractAs stated in the sister article that the objective of this study was to explore the lowcycle fatigue and ratcheting failure responses of elbow components through experimental and analytical studies. Lowcycle fatigue and ratcheting damage accumulation in piping components may occur under load reversals induced by earthquakes or thermomechanical operations. Ratcheting damage accumulation can cause failure of components through cracking or plastic buckling. Hence, design by analysis of piping components against ratcheting failure will require simulation of this response with reasonable accuracy. In developing a constitutive model that can simulate ratcheting responses of piping components, a systematic set of elbow experiments involving deformation and strain ratcheting were conducted and reported in the sister article. This article will critically evaluate seven different constitutive models against their elbow response simulation capabilities. The widely used bilinear, multilinear, and Chaboche models in ansys are first evaluated. This is followed by evaluation of the modified Chaboche, Ohno–Wang, modified Ohno–Wang, and Abdel Karim–Ohno models. Results from this simulation study are presented to demonstrate that all the seven models can simulate the elbow force response reasonably. The bilinear and multilinear models can simulate the initial elbow diameter change or strain accumulation, but always simulate shakedown during the subsequent cycles when for some of the cases the experimental trends are ratcheting. Advanced constitutive models like Chaboche, modified Chaboche, Ohno–Wang, modified Ohno–Wang, and Abdel Karim–Ohno can simulate many of the elbow ratcheting responses well, but for some of the strain responses, these models simulate negative ratcheting, which is opposite to the experimental trend. Finally, implications of negative ratcheting simulation are discussed and suggestions are made for improving constitutive models ratcheting response simulation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleConstitutive Models in Simulating Low Cycle Fatigue and Ratcheting Responses of Elbow
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4029069
dc.journal.fristpage31002
dc.journal.lastpage31002
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2015:;volume( 137 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record