Show simple item record

dc.contributor.authorScavuzzo, Rudolph J.
dc.contributor.authorUrzillo, Domenic
dc.date.accessioned2017-05-09T01:23:00Z
dc.date.available2017-05-09T01:23:00Z
dc.date.issued2015
dc.identifier.issn0094-9930
dc.identifier.otherpvt_137_02_021801.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/159458
dc.description.abstractOften when a pipe is subjected to a shock input in the vertical direction, the pipe will vibrate horizontally after initially vibrating vertically. This vibration is beating that occurs between the vertical and horizontal modes of the pipe. Beating vibration was examined analytically by considering the principal directions of the moment of inertia of the pipe with respect to the shock input direction and by varying the support direction and stiffness at each end of a pipe. Both the moment of inertia and piping supports can produce beating. The conditions needed to initiate this phenomenon are examined and results presented. Two pipe configurations are examined: a cantilever pipe and a pipe supported at each end. In both cases, the effects of varying the principal directions of the moment inertia were examined. The end conditions were varied in the supported pipe. In one case, similar vertical and horizontal supports were specified and in the second two cases vertical supports with two different stiffnesses were analyzed. Beating was found when the end supports were in different directions
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBeating in Pipes Subject to Shock
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4028839
dc.journal.fristpage21801
dc.journal.lastpage21801
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2015:;volume( 137 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record