Show simple item record

dc.contributor.authorShibutani, Tadahiro
dc.contributor.authorNakamura, Izumi
dc.contributor.authorOtani, Akihito
dc.date.accessioned2017-05-09T01:22:52Z
dc.date.available2017-05-09T01:22:52Z
dc.date.issued2015
dc.identifier.issn0094-9930
dc.identifier.otherpvt_137_01_011205.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/159420
dc.description.abstractThis paper presents a computational failure analysis of piping systems with and without thinned elbows on triaxial shake table tests. In a previous experimental study, two piping models, a sound piping system and a degraded piping system with thinned elbows, were assessed. The sound piping system was found to fail at the elbow flank due to inplane cyclic bending, whereas the degraded system failed at the end of the elbow due to excessive pipe ovalization. In the present study, finite element (FE) models of elbows were developed in order to carry out fracture analysis. The measured displacements of seismic motions were used as the boundary conditions for FE models. In the sound piping system, plastic strain concentrated at the flank of the elbow due to inplane bending. The cumulative damage factor was calculated from the fatigue curve and Miner's rule. The effect of ratcheting was also considered. In the failed elbow, the calculated cumulative damage factor showed good agreement with experimental results. On the other hand, for the fracture analysis of the thinned elbow, the entire seismic loading history on the triaxial shake table was considered, since the effect of pipe ovalization depends on loading history. The ovalization occurred at the elbow due to cumulative seismic loading. Consequently, the principal plastic strain began to concentrate at the end of the elbow. These FE results offer quantitative explanation for the observed failure modes in the degraded piping system.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFailure Analysis of Piping Systems With Thinned Elbows on Tri Axial Shake Table Tests
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4028422
dc.journal.fristpage11205
dc.journal.lastpage11205
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2015:;volume( 137 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record