Show simple item record

dc.contributor.authorRanganayakulu, Chennu
dc.contributor.authorKabelac, Stephan
dc.date.accessioned2017-05-09T01:20:04Z
dc.date.available2017-05-09T01:20:04Z
dc.date.issued2015
dc.identifier.issn0022-1481
dc.identifier.otherht_137_12_121002.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/158594
dc.description.abstractThis paper presents experimental results on boiling heat transfer of R134a in a compact plate fin heat exchanger. The exchanger is made of aluminum and has high density offset fins (30 fins/in.). Such heat exchangers are widely used in air separation industry and aerospace applications because of their high compactness and low weight. The test heat exchanger is attached to a vapor cycle refrigeration basic module to study the effects of boiling phenomena and its influence on performance as there is limited information available for this type of fins. This in turn allows for discussion on boiling mechanism of R134a inside the fins using the water circuit on the other side of the test heat exchanger. The water side single phase heat transfer coefficient (Colburn j factor) is calculated using the cfd tool fluent and validated with available open literature. The results are presented for heat fluxes up to 5500 W/m2 and mass fluxes up to 20 kg/(m2s) with water side flow rate varying from 0.033 to 0.17 kg/s for water temperatures of 10, 15, 20, 25, and 30 آ°C.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBoiling of R134a in a Plate Fin Heat Exchanger Having Offset Fins
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue12
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4030910
dc.journal.fristpage121002
dc.journal.lastpage121002
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2015:;volume( 137 ):;issue: 012
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record