Show simple item record

dc.contributor.authorLee, Jungho
dc.contributor.authorSohn, Sangho
dc.contributor.authorPark, Jaebum
dc.contributor.authorOh, Dong
dc.date.accessioned2017-05-09T01:19:49Z
dc.date.available2017-05-09T01:19:49Z
dc.date.issued2015
dc.identifier.issn0022-1481
dc.identifier.otherht_137_08_080911.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/158524
dc.description.abstractA simple use of Venturi might be used to measure twophase flow rate within relatively low GVF(gas volume fraction). Upstream flow entering Venturi can be improved with installed flow homogenizer which is easily fabricated by 3dimensional printer with multiple holes. Simultaneous measurement between highspeed flow visualization and dynamic differential pressure measurement was made to find visual criteria for twophase flow rate measurement with different GVF ranged from 0% to 30%. It was observed that the twophase flow rate can be reliably measured up to 15% of GVF using flow homogenizer. FFT(FastFourier Transform) results proved that the long flow homogenizers (type 2 and 4) showed a lower amplitude of differential pressure (خ”p) than the short flow homogenizers (type 1 and 3) respectively. So the optimized flow homogenizer can be useful to measure twophase flow rate at low GVF.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleVisual Criteria for Measuring Two phase Flow Rate in Venturi with Flow Homogenizer
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue8
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4030475
dc.journal.fristpage80911
dc.journal.lastpage80911
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2015:;volume( 137 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record