Show simple item record

dc.contributor.authorRau, Matthew J.
dc.contributor.authorGarimella, Suresh V.
dc.contributor.authorDede, Ercan M.
dc.contributor.authorJoshi, Shailesh N.
dc.date.accessioned2017-05-09T01:19:45Z
dc.date.available2017-05-09T01:19:45Z
dc.date.issued2015
dc.identifier.issn0022-1481
dc.identifier.otherht_137_07_071501.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/158498
dc.description.abstractThe effect of a variety of surface enhancements on the heat transfer achieved with an array of impinging jets is experimentally investigated using the dielectric fluid HFE7100 at different volumetric flow rates. The performance of a 5 أ— 5 array of jets, each 0.75 mm in diameter, is compared to that of a single 3.75 mm diameter jet with the same total open orifice area, in singleand twophase operation. Four different target copper surfaces are evaluated: a baseline smooth flat surface, a flat surface coated with a microporous layer, a surface with macroscale area enhancement (extended square pin–fins), and a hybrid surface on which the pin–fins are coated with the microporous layer; areaaveraged heat transfer and pressure drop measurements are reported. The array of jets enhances the singlephase heat transfer coefficients by 1.13–1.29 times and extends the critical heat flux (CHF) on all surfaces compared to the single jet at the same volumetric flow rates. Additionally, the array greatly enhances the heat flux dissipation capability of the hybrid coated pin–fin surface, extending CHF by 1.89–2.33 times compared to the single jet on this surface, with a minimal increase in pressure drop. The jet array coupled with the hybrid enhancement dissipates a maximum heat flux of 205.8 W/cm2 (heat input of 1.33 kW) at a flow rate of 1800 ml/min (corresponding to a jet diameterbased Reynolds number of 7800) with a pressure drop incurred of only 10.9 kPa. Compared to the single jet impinging on the smooth flat surface, the array of jets on the coated pin–fin enhanced surface increased CHF by a factor of over four at all flow rates.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBoiling Heat Transfer From an Array of Round Jets With Hybrid Surface Enhancements
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4029969
dc.journal.fristpage71501
dc.journal.lastpage71501
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2015:;volume( 137 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record