Show simple item record

dc.contributor.authorPonti, Fabrizio
dc.contributor.authorRavaglioli, Vittorio
dc.contributor.authorDe Cesare, Matteo
dc.contributor.authorStola, Federico
dc.date.accessioned2017-05-09T01:16:30Z
dc.date.available2017-05-09T01:16:30Z
dc.date.issued2015
dc.identifier.issn0022-0434
dc.identifier.otherds_137_06_061005.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/157533
dc.description.abstractThe continuous development of modern internal combustion engine (ICE) management systems is mainly aimed at combustion control improvement. Nowadays, performing an efficient combustion control is crucial for drivability improvement, efficiency increase (critical for spark ignited engines), and pollutant emissions reduction (critical in compression ignited engines). The most important quantities used for combustion control are engine load (indicated mean effective pressure (IMEP) or torque delivered by the engine) and center of combustion, i.e., the angular position in which 50% of fuel burned within the engine cycle is reached. Both quantities can be directly evaluated starting from incylinder pressure measurement, which could be performed using the newly developed piezoresistive pressure sensors for onboard applications. However, the use of additional sensors would increase the cost of the whole engine management system. Due to these reasons, over the past years, a methodology that allows evaluating both engine load and the center of combustion with no extra cost has been developed. This approach is based on engine speed fluctuation measurement, which can be performed using the same speed sensor already mounted onboard. The methodology is general and can be applied to different engine–driveline systems with different architectures and combustion orders. Furthermore, it is compatible with onboard requirements, since the evaluation of only one specific harmonic component of interest is required (depending on the engine–driveline configuration under investigation). In order to clarify all the issues related to the application of the presented approach, it has been applied to some different engines, both compression ignited and spark ignited, taking also into account the case of combustion not evenly spaced. For all the analyzed configurations, the results obtained using the estimation algorithm seemed to be adequate to feedback a closedloop methodology for optimal combustion control.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTorque and Center of Combustion Evaluation Through a Torsional Model of the Powertrain
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue6
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4029195
dc.journal.fristpage61005
dc.journal.lastpage61005
dc.identifier.eissn1528-9028
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2015:;volume( 137 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record