Show simple item record

dc.contributor.authorWu, Wei
dc.date.accessioned2017-05-09T01:16:22Z
dc.date.available2017-05-09T01:16:22Z
dc.date.issued2015
dc.identifier.issn0022-0434
dc.identifier.otherds_137_04_044502.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/157506
dc.description.abstractFor finer scan resolutions, the scan bar is required to move at slower speeds. Speed regulation at such low speeds presented a challenge for control. An approach successfully addressed this issue was developed. The disturbance torque in the direct current (DC) motor drive of a scan unit was calculated using the known voltage input to the motor and the measured motor speed response. The cogging torque of the motor and the friction in the mechanism can then be estimated from the calculated disturbance torque. The calculated disturbance torque was further utilized to reduce the speed ripples in speed regulation applications. A combined feedforward and feedback configuration was used to reject the disturbance based on both the offline calculated disturbance and the online estimated disturbance. This scheme was successfully implemented in consumer/commercial scan devices. Data obtained under real operating conditions demonstrated the effectiveness and robustness of this disturbance compensation scheme.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDisturbance Compensation Using Feedforward and Feedback for Scanner Direct Current Motor Mechanism Low Speed Regulation
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue4
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4029328
dc.journal.fristpage44502
dc.journal.lastpage44502
dc.identifier.eissn1528-9028
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2015:;volume( 137 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record