Show simple item record

dc.contributor.authorTamunodukobipi, Daniel
dc.contributor.authorHo Kim, Chang
dc.contributor.authorLee, Yong
dc.date.accessioned2017-05-09T01:16:13Z
dc.date.available2017-05-09T01:16:13Z
dc.date.issued2015
dc.identifier.issn0022-0434
dc.identifier.otherds_137_02_021002.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/157446
dc.description.abstractHydrodynamic instability is a prime causative of performance irregularities and violent vibrations in floatingring bearing (FRB) supported turbosystems. The quest for energyefficient solutions to this has stimulated the development of diverse FRB designgeometries, dimensional relationships, and surfacecontours. Unfortunately, these modifications are characterized mainly by modelpredictors, which results lack sufficient testdata to benchmark their authenticities. This work presents the concept and the testdata of flow redirection in FRBs by using an oilinjection swirlcontrol mechanism (OISCM) to attenuate rotordynamic instabilities. FRBs with radius ratio = 1.75 and clearance ratio = 1.5 are tested for various OISCM angles (0 deg, 30 deg, and 60 deg) and under a specific load = 50 kN/m2. The test results indicate that FRBs with OISCM demonstrate substantial improvements in damping and stability characteristics. Their whirlfrequencyratio (WFR) and crosscoupled forces are lower because of improved symmetry of films' pressureforces (Kxx ≈ Kyy). Although the magnitudes of direct damping are higher (|Cxx| = 16.92 kN s/m for 60 deg and 6.03 kN s/m for 0 deg), the load capacity (Kxx) is slightly lower than the normal (0 deg), injection. Nonetheless, this discrepancy in load capacities becomes insignificant for speeds above 22 krpm. The WFR and subsynchronous amplitudes, which are graphic reflections of the bearingbased instability, become progressively smaller with increasing OISCM angle. However, this advantage at elevated speeds can only be sustained by a corresponding increase in oilsupply pressure to circumvent the advent of a starved innerfilm and its attendant imbalance response and thermal growth. In closure, the OISCM bearing is more effective for mitigating rotordynamic instabilities in turborotors than conventional FRBs.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDynamic Performance Characteristics of Floating Ring Bearings With Varied Oil Injection Swirl Control Angles
dc.typeJournal Paper
dc.journal.volume137
dc.journal.issue2
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4027912
dc.journal.fristpage21002
dc.journal.lastpage21002
dc.identifier.eissn1528-9028
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2015:;volume( 137 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record