Show simple item record

dc.contributor.authorBukowski, Julia V.
dc.contributor.authorGross, Robert E.
dc.contributor.authorGoble, William M.
dc.date.accessioned2017-05-09T01:12:12Z
dc.date.available2017-05-09T01:12:12Z
dc.date.issued2014
dc.identifier.issn0094-9930
dc.identifier.otherpvt_136_06_061602.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/156211
dc.description.abstractExamination of proof test data for new (not previously installed) stainless steel (SS) trim spring operated pressure relief valves (SOPRV) reveals that adhesions form between the seat and disk in about 46% of all such SOPRV. The forces needed to overcome these adhesions can be sufficiently large to cause the SOPRV to fail its proof test (FPT) prior to installation. Furthermore, a significant percentage of SOPRV which are found to FPT are also found to “fail to openâ€‌ (FTO) meaning they would not relief excess pressure in the event of an overpressure event. The cases where adhesions result in FTO or FPT appear to be confined to SOPRV with diameters less than or equal to 1 in. and set pressures less than 150 pounds per square inch gauge (psig) and the FTO are estimated to occur in 0.31% to 2.00% of this subpopulation of SS trim SOPRV. The reliability and safety implications of these finding for end users who do not perform preinstallation testing of SOPRV are discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInvestigation of Adhesion Formation in New Stainless Steel Trim Spring Operated Pressure Relief Valves
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue6
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4026981
dc.journal.fristpage61602
dc.journal.lastpage61602
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2014:;volume( 136 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record