• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Flaw Testing of Fiber Reinforced Composite Pressure Vessels

    Thumbnail
    View/Open
    pvt_136_04_041409.pdf (1.623Mb)
    Date
    2014
    Author
    Makinson, John
    Newhouse, Norman L.
    Metadata
    Show full item record
    Abstract
    The ASME Boiler Pressure Vessel Project Team on Hydrogen Tanks, in conjunction with other ASME Codes and Standards groups, is developing Code Cases and revisions to the Boiler and Pressure Vessel Code, including such to address the design of composite pressure vessels. The Project Team had an interest in further understanding the effect of cuts to the surface of composite tanks, and how the burst pressure would be affected during the lifetime of the pressure vessel. A test program was initiated to provide data on initial burst pressure, and burst pressure after pressure cycling, of composite cylinders with cuts of different depth. This test program was conducted by Lincoln Composites under contract to ASME Standards Technology LLC, and was funded by National Renewable Energy Laboratory (NREL) [1]. These results were considered during the development and approval of the ASME Code Cases and Code Rules. Thirteen pressure vessels with a design pressure of 24.8 MPa (3600 psi), approximately 0.406 m (16.0 in.) in diameter and 1.02 m (40.2 in.) long, were tested to investigate the effects of cuts to the structural laminate of a composite overwrapped pressure vessel with respect to cycling and burst pressure. Two flaws, one longitudinal and one circumferential, were machined into the structural composite. The flaws were 57 mm long by 1 mm wide (2.25 in. أ— 0.04 in.) and varied in depth from 10% to 40% of the structural composite thickness of 11.4 mm (0.45 in.). These pressure vessels were cycled to design pressure 0, 10,000, and 20,000 times then burst. The resulting burst pressures were evaluated against the performance of a pressure vessel without flaws or cycling. The burst pressures were affected by depth of cut, but the pressure cycling did not have a significant effect on the burst pressure.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/156165
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV