Show simple item record

dc.contributor.authorGolden, B. J.
dc.contributor.authorLi, D. F.
dc.contributor.authorO'Dowd, N. P.
dc.contributor.authorTiernan, P.
dc.date.accessioned2017-05-09T01:11:55Z
dc.date.available2017-05-09T01:11:55Z
dc.date.issued2014
dc.identifier.issn0094-9930
dc.identifier.otherpvt_136_02_021404.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/156124
dc.description.abstractThe changing face of power generation and the increasingly severe conditions experienced by power plant materials require an improved understanding of the deformation and failure response of power plant materials. Important insights can be obtained through computational studies, where the material microstructure is explicitly modeled. In such models, the physical mechanisms of deformation and damage can be represented at the microscale, providing a more accurate prediction of material performance. In this paper, two approaches are examined to represent the microstructure of a martensitic power plant steel (P91). In one approach, the model is based on a “measured microstructureâ€‌ with electron backscatter diffraction (EBSD) employed to obtain the orientation of the martensitic grain structure of the steel. The alternative approach is to use a “numerically simulatedâ€‌ model where the microstructure is generated using the Voronoi tessellation method. In both cases, the microstructural model is incorporated within a representative volume element (RVE) in a finiteelement analysis. The material constitutive response is represented by a nonlinear, rate dependent, finite strain crystal plasticity model, with the microstructural orientation specified at each finiteelement integration point by the microstructural model. The predictions from the two approaches are compared. The stress distributions are observed to be very similar, though some differences are seen in the strain variation within the RVE.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMicrostructural Modeling of P91 Martensitic Steel Under Uniaxial Loading Conditions
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4026028
dc.journal.fristpage21404
dc.journal.lastpage21404
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2014:;volume( 136 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record