Show simple item record

dc.contributor.authorKoo, Bonjun J.
dc.contributor.authorGoupee, Andrew J.
dc.contributor.authorKimball, Richard W.
dc.contributor.authorLambrakos, Kostas F.
dc.date.accessioned2017-05-09T01:11:38Z
dc.date.available2017-05-09T01:11:38Z
dc.date.issued2014
dc.identifier.issn0892-7219
dc.identifier.otheromae_136_02_020907.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/156041
dc.description.abstractWind energy is a promising alternate energy resource. However, the onland wind farms are limited by space, noise, and visual pollution and, therefore, many countries build wind farms near the shore. Until now, most offshore wind farms have been built in relatively shallow water (less than 30 m) with fixed tower type wind turbines. Recently, several countries have planned to move wind farms to deep water offshore locations to find stronger and steadier wind fields as compared to near shore locations. For the wind farms in deeper water, floating platforms have been proposed to support the wind turbine. The model tests described in this paper were performed at MARIN (maritime research institute netherlands) with a model setup corresponding to a 1:50 Froude scaling. The wind turbine was a scaled model of the national renewable energy lab (NREL) 5 MW horizontal axis reference wind turbine supported by three different generic floating platforms: a spar, a semisubmersible, and a tensionleg platform (TLP). The wave environment used in the tests is representative of the offshore in the state of Maine. In order to capture coupling between the floating platform and the wind turbine, the 1st bending mode of the turbine tower was also modeled. The main purpose of the model tests was to generate data on coupled motions and loads between the three floating platforms and the same wind turbine for the operational, design, and survival seas states. The data are to be used for the calibration and improvement of the existing design analysis and performance numerical codes. An additional objective of the model tests was to establish the advantages and disadvantages among the three floating platform concepts on the basis of the test data. The paper gives details of the scaled model wind turbine and floating platforms, the setup configurations, and the instrumentation to measure motions, accelerations, and loads along with the wind turbine rpm, torque, and thrust for the three floating wind turbines. The data and data analysis results are discussed in the work of Goupee et al. (2012, “Experimental Comparison of Three Floating Wind Turbine Concepts,â€‌ OMAE 201283645).
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleModel Tests for a Floating Wind Turbine on Three Different Floaters
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue2
dc.journal.titleJournal of Offshore Mechanics and Arctic Engineering
dc.identifier.doi10.1115/1.4024711
dc.journal.fristpage20907
dc.journal.lastpage20907
dc.identifier.eissn1528-896X
dc.treeJournal of Offshore Mechanics and Arctic Engineering:;2014:;volume( 136 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record