Show simple item record

dc.contributor.authorSun, J. G.
dc.date.accessioned2017-05-09T01:09:35Z
dc.date.available2017-05-09T01:09:35Z
dc.date.issued2014
dc.identifier.issn0022-1481
dc.identifier.otherht_136_08_081601.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/155340
dc.description.abstractThermal properties of thermal barrier coatings (TBCs) are important parameters for the safe and efficient operation of advanced turbine engines. This paper presents a new method, the pulsed thermal imaging–multilayer analysis (PTI–MLA) method, which can measure the coating thermal conductivity and heat capacity distributions over an entire engine component surface. This method utilizes a multilayer heat transfer model to analyze the surface temperature response acquired from a onesided pulsed thermal imaging experiment. It was identified that several experimental system parameters and TBC material parameters may affect the coating surface temperature response. All of these parameters were evaluated and incorporated as necessary into the formulations. The PTI–MLA method was demonstrated by analyzing three TBC samples, and the experimental results were compared with those obtained from other methods.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePulsed Thermal Imaging Measurement of Thermal Properties for Thermal Barrier Coatings Based on a Multilayer Heat Transfer Model
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue8
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4027551
dc.journal.fristpage81601
dc.journal.lastpage81601
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2014:;volume( 136 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record