Show simple item record

dc.contributor.authorWang, Chunbai
dc.contributor.authorMitra, Ambar K.
dc.date.accessioned2017-05-09T01:09:30Z
dc.date.available2017-05-09T01:09:30Z
dc.date.issued2014
dc.identifier.issn0022-1481
dc.identifier.otherht_136_07_072101.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/155302
dc.description.abstractAmorphous fiber, ribbon, or film is produced through melt spinning. In this manufacturing process, a continuous delivery of amorphous material is simultaneously dependent on the wheel spinning rate, metallic liquid viscosity, surface tension force, heat transfer inside the melt pool and along the substrate, and other parameters. An analysis of a freejet melt spinning for fiber manufacture has been performed to relate the process control parameters with amorphous formation. We present a numerical simulation of transient impingement of a free melt jet with a rapidly rotating wheel, along with theoretical estimates of melt ribbon thickness, to investigate dynamical characteristics of the flow in melt pool. The nucleation temperature and the critical cooling rate are predicted in the paper for alloy Fe75–Si10–B15 (at. %). Thermal conduction is found to dominate undercooling in melt spinning by comparing the temperature and velocity measurements with our numerical simulation and the analytical solutions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNumerical and Analytical Modeling of Free Jet Melt Spinning for Fe75−Si10−B15 (at. %) Metallic Glasses
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4027151
dc.journal.fristpage72101
dc.journal.lastpage72101
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2014:;volume( 136 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record