Show simple item record

dc.contributor.authorLorenzini, G.
dc.contributor.authorBiserni, C.
dc.contributor.authorEstrada, E. D.
dc.contributor.authorIsoldi, L. A.
dc.contributor.authordos Santos, E. D.
dc.contributor.authorRocha, L. A. O.
dc.date.accessioned2017-05-09T01:09:30Z
dc.date.available2017-05-09T01:09:30Z
dc.date.issued2014
dc.identifier.issn0022-1481
dc.identifier.otherht_136_07_071702.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/155297
dc.description.abstractIn the present work constructal design is employed to optimize the geometry of a convective, Yshaped cavity that intrudes into a solid conducting wall. The main purpose is to investigate the influence of the dimensionless heat transfer parameter a over the optimal geometries of the cavity, i.e., the ones that minimize the maximum excess of temperature (or reduce the thermal resistance of the solid domain). The search for the best geometry has been performed with the help of a genetic algorithm (GA). For square solids (H/L = 1.0) the results obtained with an exhaustive search (which is based on solution of all possible geometries) were adopted to validate the GA method, while for H/L ≠ 1.0 GA is used to find the best geometry for all degrees of freedom investigated here: H/L, t1/t0, L1/L0, and خ± (four times optimized). The results demonstrate that there is no universal optimal shape that minimizes the thermal field for all values of a investigated. Moreover, the temperature distribution along the solid domain becomes more homogeneous with an increase of a, until a limit where the configuration of “optimal distribution of imperfectionsâ€‌ is achieved and the shape tends to remain fixed. Finally, it has been highlighted that the GA method proved to be very effective in the search for the best shapes with the number of required simulations much lower (8 times for the most difficult situation) than that necessary for exhaustive search.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleConstructal Design of Convective Y Shaped Cavities by Means of Genetic Algorithm
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4027195
dc.journal.fristpage71702
dc.journal.lastpage71702
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2014:;volume( 136 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record