Show simple item record

dc.contributor.authorDeng, D.
dc.contributor.authorXie, S. W.
dc.contributor.authorLi, X. D.
dc.contributor.authorWang, R. S.
dc.date.accessioned2017-05-09T01:09:15Z
dc.date.available2017-05-09T01:09:15Z
dc.date.issued2014
dc.identifier.issn0022-1481
dc.identifier.otherht_136_02_024501.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/155205
dc.description.abstractThe flow boiling heat transfer characteristics of liquid nitrogen in three Utubes with different curvature ratios were investigated experimentally. The effects of inlet pressure, heat flux, and curvature ratio on heat transfer characteristic are analyzed. The results indicate that the local heat transfer characteristics change obviously as fluid flows through the return bend, especially in the case of high heat flux. The drying out occurs near the inner wall of the return bend under high heat flux. A parameter Rh (down/up), which is defined as the ratio of heat transfer coefficient between the downstream and upstream section of Ubend, is proposed to evaluate the contributions of the curvature ratio to the heat transfer. It is found that the Rh (down/up) increases with the decrease of the curvature ratios. Furthermore, the experiments results of the average heat transfer coefficient are compared with the calculated results of the empirical correlations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFlow Boiling Heat Transfer of Liquid Nitrogen in Heated U Tubes
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue2
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4025542
dc.journal.fristpage24501
dc.journal.lastpage24501
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2014:;volume( 136 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record