Show simple item record

dc.contributor.authorHanifzadegan, Masih
dc.contributor.authorNagamune, Ryozo
dc.date.accessioned2017-05-09T01:06:15Z
dc.date.available2017-05-09T01:06:15Z
dc.date.issued2014
dc.identifier.issn0022-0434
dc.identifier.otherds_136_01_014503.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/154276
dc.description.abstractThis paper proposes an application of the switching gainscheduled control technique to the flexible ballscrew drive servo system with a wide range of operating conditions. The wide operating range is caused by the change of the table position and the workpiece mass during the machining operation, and leads to plant dynamics variations. To achieve high tracking performance of the table position against the dynamics variations and the cutting force disturbance, a set of gainscheduled controllers is designed so that each controller damps out the resonance of the ballscrew system and increases the closedloop bandwidth for a local operating range, and tracking performance is guaranteed under the switching between these controllers. Experimental results with a laboratoryscale ballscrew drive setup demonstrate that the switching gainscheduled controller outperforms the nonswitching one by up to 52% in tracking accuracy.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSwitching Gain Scheduled Control Design for Flexible Ball Screw Drives
dc.typeJournal Paper
dc.journal.volume136
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4025154
dc.journal.fristpage14503
dc.journal.lastpage14503
dc.identifier.eissn1528-9028
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2014:;volume( 136 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record