• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Development of Leak Before Break Assessment Method for Japan Sodium Cooled Fast Reactor Pipe—Part 1 Crack Opening Displacement Assessment of Thin Wall Pipes Made of Modified 9Cr 1Mo Steel

    Thumbnail
    View/Open
    pvt_135_1_011401.pdf (1.170Mb)
    Date
    2013
    Author
    Wakai, Takashi
    Machida, Hideo
    Arakawa, Manabu
    Yoshida, Shinji
    Enuma, Yasuhiro
    Metadata
    Show full item record
    Abstract
    This was carried out to establish crack opening displacement (COD) evaluation methods used in leakbeforebreak (LBB) assessment of sodium pipes of the Japan sodium cooled fast reactor (JSFR). For sodium pipes of JSFR, the continuous leak monitoring will be adopted as an alternative to a volumetric test of the weld joints under conditions that satisfy LBB. The sodium pipes are made of ASME Gr.91 (modified 9Cr1Mo steel). Thickness of the pipes is small, because the internal pressure is very low. Modified 9Cr1Mo steel has a relatively large yield stress and small work hardening coefficient comparing to the austenitic stainless steels which are currently used in the conventional plants. In order to assess the LBB behavior of the sodium pipes made of modified 9Cr1Mo steel, the coolant leak rate from a throughwall crack must be estimated properly. Since the leak rate is strongly related to the COD, an appropriate COD assessment method must be established to perform LBB assessment. However, COD assessment method applicable for JSFR sodium pipes—thin wall and small work hardening material—has not been proposed yet. Thus, a COD assessment method applicable to thin walled large diameter pipe made of modified 9Cr1Mo steel was proposed in this study. In this method, COD was calculated by classifying the components of COD; elastic, local plastic, and fully plastic. In addition, the verification of this method was performed by comparing with the results of a series of fourpoint bending tests at elevated temperature using thin wall modified 9Cr1Mo steel pipe containing a circumferential throughwall crack. As a result, COD values calculated by the proposed method were in a good agreement with the experimental results for the uniform pipe without a weld. In the case that the crack was machined in the weld metal or heat affected zone (HAZ), the proposed method predicted relatively larger COD than the experimental results. The causes of such discrepancies were discussed by comparing with the results of finite element analyses. Based on these examinations, the rational leak rate evaluation method in LBB assessment was proposed.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/153028
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV