• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    On the Use of Shape Memory Alloy Studs to Recover Load Loss in Bolted Joints

    Thumbnail
    View/Open
    pvt_135_2_021203.pdf (1.610Mb)
    Date
    2013
    Author
    Ould
    Bouzid, Abdel
    Brailovski, Vladimir
    Metadata
    Show full item record
    Abstract
    Creep is an important factor that contributes to the clamp load loss and tightness failure of bolted joints with and without gaskets over time. Retightening of the joint can be expensive and time consuming; therefore, it is an undesirable solution. Currently, most efforts are put towards reducing load losses directly by tightening to yield, improving material creep properties, or making joint less rigid. An alternative solution of current interest is the use of bolts in shape memory alloys (SMAs). However, very few experimental studies are available, which demonstrate the feasibility of these alloys. The objective of this study is to explore the benefit of shape memory and superelasticity behavior of an SMA stud to recover load losses due to creep and thermal exposure of a gasket in a boltedjoint assembly. This paper explores several venues to investigate and model the thermomechanical behavior of a bolted joint with a nickel–titanium SMA stud. A stiffnessbased analytical model which incorporates the Likhachev model of SMA is used as a representation of an experimental boltedjoint assembly. Based on this model, the rigidity of the experimental setup is optimized to make the best use of the SMA properties of the stud. This analytical model is compared with a finite element model, which also implements the Likhachev's material law. Finally, an experimental test bench with a relatively low stiffness representative of standard flanges is used, with and without gaskets to demonstrate the ability of the SMA stud to recover load losses due to gasket creep.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/152985
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV