Efficient Machining of Microdimples for Friction Reduction

Abstract

In order to improve the tribological properties of thermomechanically highly stressed surfaces such as cylinder liners, microdimples are produced by flycutting kinematics along the functional surface. The structures are used to hold back lubricant but also to increase the hydrodynamic pressure, which is built up between the sliding friction partners. For that, machining strategies for the pattern generation in cylindrical components are developed as well as a mathematical model of the microdimple arrangement and distribution. The tribological performance of the machined microdimples is analyzed by means of ringondisk experiments. At low sliding speeds the friction coefficient can be decreased clearly by microdimples. This indicates the potential for lowspeed or reciprocating tribosystems like cylinder liners. This potential is quantified by motor driven experiments and the comparison between structured and nonstructured cylinder liners. A honed (fine) liner with additional microdimples along the interstice area shows friction losses up to 19% compared to standard honed nonstructured cylinder liner.