• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Dynamic Calibration of a Coaxial Thermocouples for Short Duration Transient Measurements

    Thumbnail
    View/Open
    ht_135_12_124502.pdf (1.132Mb)
    Date
    2013
    Author
    Kumar, Rakesh
    Sahoo, Niranjan
    Metadata
    Show full item record
    Abstract
    Coaxial thermocouple sensors are suitable for measuring highly transient surface heat fluxes because the response times of these sensors are very small (∼0.1 ms). These robust sensors have the flexibility of mounting them directly on the surface of any geometry. So, they have been routinely used in groundbased impulse facilities as temperature sensors where rapid changes in heat loads are expected on aerodynamic models. Subsequently, the surface heat fluxes are predicted from the transient temperatures by appropriate onedimensional heat conduction modeling for semiinfinite body. In this backdrop, the purpose of this work is to design and fabricate Ktype coaxial thermocouples inhouse and calibrate them under similar nature of heat loads by using simple laboratory instruments. Here, two methods of dynamic calibration of coaxial thermocouples have been discussed, where the known step loads are applied through radiation and conduction modes of heat transfer. Using appropriate one dimensional heat conduction modeling, the surface heat fluxes are predicted from the measured temperature histories and subsequently compared with the input heat loads. The recovery of surface heat flux from laser based calibration experiment underpredicts by 4% from its true input heat load. Similarly, recovery of surface heat flux from the conduction mode calibration experiments underpredicts 6% from its true input value. Further, finiteelement based numerical study is performed on the coaxial thermocouple model to obtain surface temperatures with same heat loads as used in the experiments. The recovery of surface temperatures from finite element simulation is achieved within an accuracy of آ±0.3% from the experiment.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/152291
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV