Show simple item record

dc.contributor.authorJi, Yulong
dc.contributor.authorXu, Chen
dc.contributor.authorMa, Hongbin
dc.contributor.authorXinxiang, Pan
dc.date.accessioned2017-05-09T00:59:51Z
dc.date.available2017-05-09T00:59:51Z
dc.date.issued2013
dc.identifier.issn0022-1481
dc.identifier.otherht_135_7_074504.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/152168
dc.description.abstractThis paper presents an experimental investigation of whether heat transfer performance in an oscillating heat pipe (OHP) would improve if the inner surface of the heat pipe was coated with a layer of copper oxide (CuO). The OHP had six turns and three sections, i.e., evaporator, condenser, and adiabatic section with lengths of 40 mm, 64 mm, and 51 mm, respectively. The cleaned copper tubing was chemically treated with a chemical solution and heated in a furnace. A microstructure layer of CuO was formed in the inner surface of the OHP with K2S2O8 and KOH. The working fluid in this study was water with filling ratios ranging from 40% to 70%. The experimental results show that the CuO microstructure layer is superhydrophilic and can enhance the OHP heat transfer performance. The investigation results in a new way to enhance the heat transfer performance of an OHP.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Investigation of the Heat Transfer Performance of an Oscillating Heat Pipe With Copper Oxide (CuO) Microstructure Layer on the Inner Surface
dc.typeJournal Paper
dc.journal.volume135
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4023749
dc.journal.fristpage74504
dc.journal.lastpage74504
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2013:;volume( 135 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record