Show simple item record

dc.contributor.authorMiner, Mark J.
dc.contributor.authorPhelan, Patrick E.
dc.contributor.authorOdom, Brent A.
dc.contributor.authorOrtiz, Carlos A.
dc.contributor.authorPrasher, Ravi S.
dc.contributor.authorSherbeck, Jon A.
dc.date.accessioned2017-05-09T00:59:42Z
dc.date.available2017-05-09T00:59:42Z
dc.date.issued2013
dc.identifier.issn0022-1481
dc.identifier.otherht_135_4_042901.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/152107
dc.description.abstractThis study discusses the simulation of flow boiling in a microchannel and numerically predicts the effects of channel geometry variation along the flow direction. Experimental studies by Pan and collaborators and suggestions from Mukherjee and Kandlikar have generated interest in expanding the cross section of a microchannel to improve boiling heat transfer. The motivation for this geometry change is discussed, constraints and model selection are reviewed, and Revellin and Thome's critical heat flux criterion is used to bound the simulation, via matlab, of separated flow in a heated channel. The multiphase convective heattransfer coefficient is extracted from these results using Qu and Mudawar's relationship and is compared to reported experimental values. Expanding channel geometry permits higher heat rates before reaching critical heat flux.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOptimized Expanding Microchannel Geometry for Flow Boiling
dc.typeJournal Paper
dc.journal.volume135
dc.journal.issue4
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4023260
dc.journal.fristpage42901
dc.journal.lastpage42901
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2013:;volume( 135 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record