Show simple item record

dc.contributor.authorMohapatra, Soumya S.
dc.contributor.authorRavikumar, Satya V.
dc.contributor.authorVerma, Ankur
dc.contributor.authorPal, Surjya K.
dc.contributor.authorChakraborty, Sudipto
dc.date.accessioned2017-05-09T00:59:33Z
dc.date.available2017-05-09T00:59:33Z
dc.date.issued2013
dc.identifier.issn0022-1481
dc.identifier.otherht_135_3_032101.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/152040
dc.description.abstractThe requirement for high tensile strength steel has placed greater emphasis on the cooling methods used in the cooling of a hot steel plate. The purpose of this research is to study the effect of surfactant concentration in water jet cooling, and its applicability in the study of ultrafast cooling (UFC) of a hot steel plate. The initial temperature of the plate, before the cooling starts, is kept at 900 آ°C which is usually observed as the “finish rolling temperature (FRT)â€‌ in the hot strip mill of a steel plant. The current heat transfer analysis shows that surfactant added water jet produces higher heat flux than the pure water jet due to the higher forced convection cooling area. Dissolved surfactant increases the transition boiling heat flux, nucleate boiling heat flux and critical heat flux. At a concentration of 600 ppm, the maximum surface heat flux has been observed and further increase in surfactant concentration decreases the surface heat flux. The surface heat flux and the cooling rate show an increasing trend with the increasing water flow rate at a constant surfactant concentration. The achieved cooling rate in case of surfactant added water is almost twice that of jet with pure water, resulting in ultrafast cooling. By assuming the impinging surface consists of three different constant heat flux regions, the surface heat flux and the surface temperatures have been calculated by using intemp software.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Investigation of Effect of a Surfactant to Increase Cooling of Hot Steel Plates by a Water Jet
dc.typeJournal Paper
dc.journal.volume135
dc.journal.issue3
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4007878
dc.journal.fristpage32101
dc.journal.lastpage32101
dc.identifier.eissn1528-8943
dc.treeJournal of Heat Transfer:;2013:;volume( 135 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record