Analysis and Design of a Small, Two Bar Creep Test Specimen

Abstract

In this paper, a new smallsized (twobar) specimen type, which is suitable for use in obtaining both uniaxial creep strain and creep rupture life data, is described. The specimen has a simple geometry and can be conveniently machined and loaded (through pinconnections) for testing. Conversion relationships between the applied load and the corresponding uniaxial stress, and between the measured loadline deformations and the corresponding uniaxial minimum creep strain rate, have been obtained, based on the reference stress method (RSM), in conjunction with finite element analyses. Using finite element analyses the effects of the specimen dimensions on reference stress parameters have been investigated. On this basis, specimen dimension ratio ranges are recommended. The effects of friction, between the loading pins and the specimen surfaces, on the specimen failure time, are also investigated. Test results obtained from twobar specimen tests and from corresponding uniaxial specimen tests, for a P91 steel at 600 آ°C, are used to validate the test method. These results demonstrated that the specimen type is capable of producing full uniaxial creep strain curves. The advantages of this new, small, creep test specimen, for determining uniaxial creep data, are discussed and recommendations for future research are given.