Show simple item record

dc.contributor.authorDavid E. Lambert
dc.contributor.authorJohn Osborn
dc.contributor.authorMichael V. Hopson
dc.date.accessioned2017-05-09T00:54:03Z
dc.date.available2017-05-09T00:54:03Z
dc.date.copyrightJune, 2012
dc.date.issued2012
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28567#031209_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/150118
dc.description.abstractThe explosively loaded right-circular tube geometry is used as the basis for dynamic fracture and fragmentation modeling. Details of the cylinder configuration are investigated to prescribe controlled loading conditions of uniaxial stress and plane strain. Earlier works by Goto et al. [2008, “Investigation of the Fracture and Fragmentation of Explosively Driven Rings and Cylinders,” Int. J. Impact Eng. 35 (12), pp. 1547–1556] had used thin-walled tubes to provide plane strain loading and shorter “rings” to establish uniaxial stress conditions. This paper extends on that work to look at alternative cylinder dimensions and metals of interest. A tungsten alloy, Aero-224, and a high strength steel, Eglin Steel (ES-1), are the subject metals. Transient continuum-mechanics simulations evaluated whether the stress triaxiality conditions were being met as design parameters of cylinder material, cylinder wall-thickness, cylinder length, and initiation configuration were varied. Design analysis shows that the thin cylinders of ES-1 steel do establish the desired plane strain conditions as it expands to failure. Ultra-high speed photography experiments verify the time of fracture and correlate casewall expansion and velocity measurements. Synchronization of the code and diagnostics measurements is presented as a valuable analysis method. On the other hand, rings (i.e., uniaxial stress) of the Aero-224 tungsten alloy were failing just short of uniaxial stress approximating conditions. Analysis of the Aero-224 rings indicated it must be capable of achieving at least a 25% strain to failure in order to have the triaxiality condition satisfied. Strain to failure measurements directly from recovered fragments were less than 14%. Nevertheless, a Weibull distribution was fit to the empirical data set and used to drive a statistically compensated fracture model. Results and discussion of the failure strain distribution and the ability for continuum codes to adequately conduct such simulations are presented.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExplosively Driven Fragmentation Experiments for Continuum Damage Modeling
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4006119
dc.journal.fristpage31209
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsFracture (Process)
dc.keywordsModeling
dc.keywordsCylinders
dc.keywordsFailure
dc.keywordsPlane strain
dc.keywordsWall thickness
dc.keywordsSteel
dc.keywordsExplosions
dc.keywordsEngineering simulation
dc.keywordsDesign AND Dimensions
dc.treeJournal of Pressure Vessel Technology:;2012:;volume( 134 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record