Show simple item record

dc.contributor.authorWilliam S. de Rosset
dc.date.accessioned2017-05-09T00:54:01Z
dc.date.available2017-05-09T00:54:01Z
dc.date.copyrightAugust, 2012
dc.date.issued2012
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-926073#041009_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/150103
dc.description.abstractThe development of a process to emplace a refractory metal liner inside a gun tube is described. The process consists of filling the liner with an elastomeric material and then slipping this arrangement into the gun tube. The ends of the liner are plugged with plastic disks and pressure is applied to the elastomeric material by a load frame. Plastic deformation of the gun tube results in residual radial stresses that induce a frictional bond between the liner and gun tube. Efforts are described to increase the bond strength through increasing the coefficient of friction.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleGun Liner Emplacement
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4007008
dc.journal.fristpage41009
dc.identifier.eissn1528-8978
dc.keywordsFriction
dc.keywordsStress
dc.keywordsBond strength
dc.keywordsCylinders
dc.keywordsGun barrels
dc.keywordsPressure
dc.keywordsSteel AND Deformation
dc.treeJournal of Pressure Vessel Technology:;2012:;volume( 134 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record