Show simple item record

dc.contributor.authorS. Vishnuvardhan
dc.contributor.authorSumit Goyal
dc.contributor.authorSuneel K. Gupta
dc.contributor.authorG. Raghava
dc.contributor.authorP. Gandhi
dc.contributor.authorVivek Bhasin
dc.contributor.authorK. K. Vaze
dc.contributor.authorM. Saravanan
dc.contributor.authorD. M. Pukazhendhi
dc.date.accessioned2017-05-09T00:53:59Z
dc.date.available2017-05-09T00:53:59Z
dc.date.copyrightAugust, 2012
dc.date.issued2012
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-926073#041203_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/150087
dc.description.abstract“Ratcheting” is a phenomenon which leads to reduction in fatigue life of a structural component by loss of ductility due to cycle by cycle accumulation of plastic strain. Ratcheting occurs in a structure subjected to a combination of steady/sustained and cyclic loads such that the material response is in inelastic region. Ratcheting studies were carried out on Type 304LN stainless steel elbows, subjected to steady internal pressure and cyclic bending. The elbows filled with water were pressurized between 27.6 MPa and 39.2 MPa. Cyclic bending load, under opening and closing moments, was applied on the elbows at ambient temperature. Number of cycles corresponding to occurrence of a through-wall crack was recorded. Crack was observed in the bent portion at one of the crown locations in all the four specimens. Maximum strain was observed at the intrados and crown locations of the elbows. The ratcheting strain increased with number of cycles at crown and intrados locations. However, the strain accumulation rate decreased with number of cycles. Strain was observed to be minimum at the extrados location and the same stabilized toward the end of the tests. The specimens have failed by occurrence of through-wall axial crack accompanied by simultaneous ballooning. The ballooning was found to be varying from 3.8% to 5.8% with respect to the original circumference in the bent portion. The reduction in thickness was found to be around 12%–15%.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRatcheting Studies on Type 304LN Stainless Steel Elbows subjected to Combined Internal Pressure and In-Plane Bending Moment
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4005886
dc.journal.fristpage41203
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsStress
dc.keywordsStainless steel
dc.keywordsCycles
dc.keywordsThickness AND Fracture (Materials)
dc.treeJournal of Pressure Vessel Technology:;2012:;volume( 134 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record