Show simple item record

dc.contributor.authorHamid Jahed
dc.contributor.authorMohammad Reza Faritus
dc.contributor.authorZeinab Jahed
dc.date.accessioned2017-05-09T00:53:57Z
dc.date.available2017-05-09T00:53:57Z
dc.date.copyrightOctober, 2012
dc.date.issued2012
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-926074#051501_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/150073
dc.description.abstractRelieved strains due to drilling hole in a ring sample cut from an autofrettage cylinder are measured. Measured strains are then transformed to residual stresses using calibration constants and mathematical relations of elasticity based on ASTM standard recommendations (American Society for Testing and Materials, ASTM E 837-08, 2008, “Standard Test Method for Determining Residual Stresses by the Hole-Drilling Strain-Gage Method,” American Society for Testing and Materials). The hydraulic autofrettage is pressurizing a closed-end long cylinder beyond its elastic limits and subsequently removing the pressure. In contrast to three-dimensional stress state in the autofrettage tube, the stress measurement in hole drilling method is performed on a traction free surface formed from cutting the ring sample. The process of cutting the ring sample from a long autofrettaged tube is simulated using finite element method (FEM) and the redistribution of the residual stress due to the cut is discussed. Hence, transformation of the hole drilling measurements on the ring slice to the autofrettage residual stresses is revealed. The residual stresses are also predicted by variable material properties (VMP) method (Jahed, H., and Dubey, R. N., 1997, “An Axisymmetric Method of Elastic-Plastic Analysis Capable of Predicting Residual Stress Field,” Trans. ASME J. Pressure Vessel Technol., 119 , pp. 264–273) using real loading and unloading behavior of the test material. Prediction results for residual hoop stress agree very well with the measurements. However, radial stress predictions are less than measured values particularly in the middle of the ring. To remove the discrepancy in radial residual stresses, the measured residual hoop stress that shows a self-balanced distribution was taken as the basis for calculating residual radial stresses using field equations of elasticity. The obtained residual stresses were improved a lot and were in good agreement with the VMP solution.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleResidual Stress Measurements in an Autofrettage Tube Using Hole Drilling Method
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue5
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4007072
dc.journal.fristpage51501
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsAutofrettage
dc.keywordsDrilling
dc.keywordsMeasurement AND Residual stresses
dc.treeJournal of Pressure Vessel Technology:;2012:;volume( 134 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record