Show simple item record

dc.contributor.authorYuan Gexia
dc.contributor.authorLiu Hongzhao
dc.date.accessioned2017-05-09T00:53:52Z
dc.date.available2017-05-09T00:53:52Z
dc.date.copyright41244
dc.date.issued2012
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-926532#pvt_134_6_061209.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/150042
dc.description.abstractTo enhance the pressure capacity and the life of a pressure vessel, different processes such as shrink-fit and autofrettage are usually employed. For autofrettaged and shrink-fit multilayer cylinders, numerical solutions for determining the residual stress distribution have been reported. However, few studies about the analytical method are available. In this study, an analytical solution was presented for shrink-fit two-layer cylinders after autofrettage based on the actual tensile-compressive stress–strain curve of material. The new analytical method accurately predicted a residual stress distribution, and it could be used to design two-layer compound cylinders. In this method, unloading and shrink-fitting were considered as a simultaneous operation for an inner cylinder, allowing for a simple and accurate analysis. Some significant factors were taken into account, including the nonlinear behavior of an original autofrettaged inner layer in the shrink-fitting process and a material’s different unloading behavior at different maximum tensile affects back-yielding. The results of the proposed method were in excellent agreement with the results from the simulation performed by ansys. The results indicated that an increased shrink-fit pressure expanded the back-yielding zone of the inner cylinders, and did not affect the back-yielding zone of the outer cylinders. The optimum percentages overstrain depend on the working pressure when the shrink-fit pressure, cylinder size, and material are defined, and inner and outer cylinders have different optimum percentages overstrain.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Analytical Solution of Residual Stresses for Shrink-Fit Two-Layer Cylinders After Autofrettage Based on Actual Material Behavior
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue6
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.4006121
dc.journal.fristpage61209
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;2012:;volume( 134 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record