Show simple item record

dc.contributor.authorWei Xu
dc.contributor.authorChang-Hwan Choi
dc.date.accessioned2017-05-09T00:52:19Z
dc.date.available2017-05-09T00:52:19Z
dc.date.copyrightMay, 2012
dc.date.issued2012
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27940#051022_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/149476
dc.description.abstractIn this paper, the evaporation kinetics of microliter-sized sessile droplets of gold colloids (∼250 nm in particle diameters) was experimentally studied on micropatterned superhydrophobic surfaces, compared with those of pure water on a planar hydrophobic surface. The structural microtopography of superhydrophobic surfaces was designed to have a constant air fraction (∼0.8) but varying array patterns including pillars, lines, and wells. During evaporation in a room condition, the superhydrophobic surfaces exhibited a stronger pinning effect than a planar surface, especially in the initial evaporation stage, with significant variations by the surface topographies. Compared to a pure water droplet, colloids exhibited further promoted pinning effects, mainly in the later stage of evaporation. While the well-known evaporative mass transport law of sessile droplets (i.e., linear law of “V2/3∝t”) was generally applicable to the superhydrophobic surfaces, much smaller evaporation rate constants were measured on the patterned superhydrophobic surfaces than on a planar hydrophobic surface. A colloidal droplet further showed lower evaporation rate constants than a pure water droplet as the concentration of particles in the droplets increased over the evaporation. Such transition was more dramatic on a planar surface than on the micropatterned surfaces. Whereas there was no clear correlation between evaporation mode and the evaporation rate observed on the superhydrophobic surfaces, the prominent decrease of the evaporation rate on the planar hydrophobic surface was accompanied with the onset of a second pinning mode.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffects of Surface Topography and Colloid Particles on the Evaporation Kinetics of Sessile Droplets on Superhydrophobic Surfaces
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue5
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4005715
dc.journal.fristpage51022
dc.identifier.eissn1528-8943
dc.keywordsParticulate matter
dc.keywordsEvaporation
dc.keywordsWater AND Columns (Structural)
dc.treeJournal of Heat Transfer:;2012:;volume( 134 ):;issue: 005
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record