Show simple item record

dc.contributor.authorManoj Kumar Moharana
dc.contributor.authorPiyush Kumar Singh
dc.contributor.authorSameer Khandekar
dc.date.accessioned2017-05-09T00:52:07Z
dc.date.available2017-05-09T00:52:07Z
dc.date.copyrightJuly, 2012
dc.date.issued2012
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27945#071703_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/149418
dc.description.abstractA numerical study has been carried out to understand and highlight the effects of axial wall conduction in a conjugate heat transfer situation involving simultaneously developing laminar flow and heat transfer in a square microchannel with constant flux boundary condition imposed on bottom of the substrate wall. All the remaining walls of the substrate exposed to the surroundings are kept adiabatic. Simulations have been carried out for a wide range of substrate wall to fluid conductivity ratio (ksf ∼ 0.17–703), substrate thickness to channel depth (δsf ∼ 1–24), and flow rate (Re ∼ 100–1000). These parametric variations cover the typical range of applications encountered in microfluids/microscale heat transfer domains. The results show that the conductivity ratio, ksf is the key factor in affecting the extent of axial conduction on the heat transport characteristics at the fluid–solid interface. Higher ksf leads to severe axial back conduction, thus decreasing the average Nusselt number (Nu¯). Very low ksf leads to a situation which is qualitatively similar to the case of zero-thickness substrate with constant heat flux applied to only one side, all the three remaining sides being kept adiabatic; this again leads to lower the average Nusselt number (Nu¯). Between these two asymptotic limits of ksf , it is shown that, all other parameters remaining the same (δsf and Re), there exists an optimum value of ksf which maximizes the average Nusselt number (Nu¯). Such a phenomenon also exists for the case of circular microtubes.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOptimum Nusselt Number for Simultaneously Developing Internal Flow Under Conjugate Conditions in a Square Microchannel
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue7
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4006110
dc.journal.fristpage71703
dc.identifier.eissn1528-8943
dc.keywordsHeat transfer
dc.keywordsFluids
dc.keywordsChannels (Hydraulic engineering)
dc.keywordsFlow (Dynamics)
dc.keywordsHeat
dc.keywordsHeat conduction
dc.keywordsBoundary-value problems
dc.keywordsConductivity
dc.keywordsThickness
dc.keywordsMicrochannels
dc.keywordsHeat flux
dc.keywordsTemperature
dc.keywordsInternal flow
dc.keywordsWall thickness
dc.keywordsEngineering simulation
dc.keywordsDucts AND Laminar flow
dc.treeJournal of Heat Transfer:;2012:;volume( 134 ):;issue: 007
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record