| dc.contributor.author | Ki-Don Lee | |
| dc.contributor.author | Kwang-Yong Kim | |
| dc.date.accessioned | 2017-05-09T00:51:57Z | |
| dc.date.available | 2017-05-09T00:51:57Z | |
| dc.date.copyright | October, 2012 | |
| dc.date.issued | 2012 | |
| dc.identifier.issn | 0022-1481 | |
| dc.identifier.other | JHTRAO-926055#101702_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/149337 | |
| dc.description.abstract | This paper presents a numerical investigation of the film-cooling performance of a novel film-cooling hole in comparison with a fan-shaped hole. The novel shaped hole is designed to increase the lateral spreading of coolant on the cooling surface. The film-cooling performance of the novel shaped hole is evaluated at a density ratio of 1.75 and the range of the blowing ratio of 0.5–2.5. The simulations were performed using three-dimensional Reynolds-averaged Navier–Stokes analysis with the SST k-ω model. The numerical results for the fan-shaped hole show very good agreement with the experimental data. For the blowing ratio of 0.5, the novel shaped film-cooling hole shows a similar cooling performance as the fan-shaped hole. However, as the blowing ratio increases, the novel shaped hole shows greatly improved lateral spreading of the coolant and the cooling performance in terms of the film-cooling effectiveness in comparison with the fan-shaped hole. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Performance Evaluation of a Novel Film-Cooling Hole | |
| dc.type | Journal Paper | |
| dc.journal.volume | 134 | |
| dc.journal.issue | 10 | |
| dc.journal.title | Journal of Heat Transfer | |
| dc.identifier.doi | 10.1115/1.4006752 | |
| dc.journal.fristpage | 101702 | |
| dc.identifier.eissn | 1528-8943 | |
| dc.keywords | Cooling AND Coolants | |
| dc.tree | Journal of Heat Transfer:;2012:;volume( 134 ):;issue: 010 | |
| dc.contenttype | Fulltext | |