Show simple item record

dc.contributor.authorAhmed E. E. Khalil
dc.contributor.authorKenneth M. Bryden
dc.contributor.authorSang C. Lee
dc.contributor.authorAshwani K. Gupta
dc.date.accessioned2017-05-09T00:49:37Z
dc.date.available2017-05-09T00:49:37Z
dc.date.copyrightSeptember, 2012
dc.date.issued2012
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-926028#032201_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/148635
dc.description.abstractDistributed combustion is now known to provide significantly improved performance of gas turbine combustors. Key features of distributed combustion include uniform thermal field in the entire combustion chamber for significantly improved pattern factor and avoidance of hot-spot regions that promote thermal NOx emissions, negligible emissions of hydrocarbons and soot, low noise, and reduced air cooling requirements for turbine blades. Distributed combustion requires controlled mixing between the injected air, fuel, and hot reactive gasses from within the combustor prior to mixture ignition. The mixing process impacts spontaneous ignition of the mixture to result in improved distributed combustion reactions. Distributed reactions can be achieved in premixed, partially premixed, or nonpremixed modes of combustor operation with sufficient entrainment of hot and active species present in the combustion zone and their rapid turbulent mixing with the reactants. Distributed combustion with swirl is investigated here to further explore the beneficial aspects of such combustion under relevant gas turbine combustion conditions. The near term goal is to develop a high intensity combustor with ultralow emissions of NOx and CO, and a much improved pattern factor and eventual goal of near zero emission combustor. Experimental results are reported for a cylindrical geometry combustor for different modes of fuel injection with emphasis on the resulting pollutants emission. In all the cases, air was injected tangentially to impart swirl to the flow inside the combustor. Ultra low NOx emissions were found for both the premixed and nonpremixed combustion modes for the geometries investigated here. Results showed very low levels of NO (∼10 ppm) and CO (∼21 ppm) emissions under nonpremixed mode of combustion with air preheats at an equivalence ratio of 0.6 and a moderate heat release intensity of 27 MW/m3 -atm. Results are also reported on lean stability limits and OH* chemiluminescence under different fuel injection scenarios for determining the extent of distribution combustion conditions. Numerical simulations have also been performed to help develop an understanding of the mixing process for better understanding of ignition and combustion.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMixture Preparation Effects on Distributed Combustion for Gas Turbine Applications
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4006481
dc.journal.fristpage32201
dc.identifier.eissn1528-8994
dc.keywordsCombustion
dc.keywordsFuels
dc.keywordsCombustion chambers
dc.keywordsGas turbines
dc.keywordsIgnition
dc.keywordsMixtures
dc.keywordsEmissions
dc.keywordsFlames
dc.keywordsPollution
dc.keywordsTemperature AND Flow (Dynamics)
dc.treeJournal of Energy Resources Technology:;2012:;volume( 134 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record