Show simple item record

dc.contributor.authorWanan Sheng
dc.contributor.authorAnthony Lewis
dc.date.accessioned2017-05-09T00:49:35Z
dc.date.available2017-05-09T00:49:35Z
dc.date.copyrightDecember, 2012
dc.date.issued2012
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-926220#jert_134_4_041701.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/148624
dc.description.abstractIn developing a wave energy converter (WEC), assessing and rating the device is a difficult, but important issue. Conventionally, a large scaled device (maybe large enough for accommodating a power takeoff (PTO) system) or prototype device is needed to be tested in wave tanks or in seas in different wave conditions so that a power matrix for the device can be defined using scaling or interpolation/extrapolation methods. Alternatively, a pure numerical simulation in time-domain may be used for assessing the power capture capacities of wave energy devices. For the former, it is convincing, but can be especially difficult in the early stages of development, when small scaled models are normally used; and for the latter, the pure numerical simulation may not be very reliable and convincing, especially when the dynamic problem is very complicated. In this paper, a method for assessing the captured wave power for a device from its power capture response is presented. In the proposed method, a measured or calculated linear power capture response of the device is combined with wave spectrum to compute the average captured power function. Once the average captured power function is obtained, the overall average captured power corresponding to the wave state can be easily calculated. If a linear power capture response is obtained from a model test, the power assessment based on this proposed method can be very convincing and reliable. To illustrate the application of the proposed method, an example of a fully linear dynamic system, including the linear hydrodynamics of the floating structure and a linear power takeoff, is considered. For such a system, the frequency-domain analysis can be employed to obtain the performance of the floating device under waves and the power takeoff system. The hydrodynamic performance of the wave energy converter is then used to define the power capture response and to calculate the average captured power functions in different sea states. Then, the captured power of the device in different sea states, i.e, the power matrix, can be calculated, and accordingly, the device can be assessed and rated. To validate the proposed method, a time-domain analysis is also performed for a cross-check. In the time-domain analysis, the hydrodynamic coefficients and responses are first assessed in frequency-domain, and then transformed into the relevant terms by means of impulse response functions for establishing the time-domain (TD) equation. By comparing the results from frequency-domain and time-domain analyses of irregular waves, it can be concluded that the proposed wave energy capture assessment method can be used in assessing or rating the device.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAssessment of Wave Energy Extraction From Seas: Numerical Validation
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4007193
dc.journal.fristpage41701
dc.identifier.eissn1528-8994
dc.keywordsForce
dc.keywordsWaves
dc.keywordsImpulse (Physics)
dc.keywordsWave energy
dc.keywordsSeas
dc.keywordsMotion
dc.keywordsWave power generation
dc.keywordsTime-domain analysis
dc.keywordsSpectra (Spectroscopy) AND Wave energy converters
dc.treeJournal of Energy Resources Technology:;2012:;volume( 134 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record